Change oil and oil filter. Check air filter and breather filter. Check all fluid levels and tire pressures. Preform basic safety inspection. Road test vehicle.
MILAGROS M. gave our service a 5 star review on 11/3/2021
FRONT BRAKES BELLOW SPECS. AND MAKES GRINDING NOISE WHEN HARD STOP, RECOMMEND FRONT BRAKE PADS AND REPLACEMENT. ALSO SOME MOTOR OIL LEAKING BETWEEN ENGINE AND TRANSMISSION, POSSIBLE REAR MAIN SEAL FURTHER DIAGNOSTIC NEEDED, CUSTOMER WAS ADVICE TO CALL TOYOTA DEALER TO FIND OUT IF REPAIRS COULD BE UNDER MANUFACTURE'S WARRANTY.
BRAKE SHOES &/OR PADS – Remove & Replace – Gas Front or Rear,Both Sides – [Includes: Clean, lube and/or replace Brake Hardware as necessary. Adjust Brakes (where applicable). Includes: Repack Wheel Bearings (where applicable). DOES NOT include refinishin
VINCENT B. gave our service a 5 star review on 8/7/2021
ALTERNATOR ASSEMBLY – Remove & Replace – Eng VIN R,Eng CD 1ZZ-FE
VEHICLE DOES NOT START BATTERY LOW ON CHARGE, ALTERNATOR UNDERCHARGING AT 9.3 VOLTS, RECOMMEND ALTERNATOR REPLACEMENT FIRST THEN RECHECK FOR BATTERY CONDITION.
MAX N. gave our service a 5 star review on 1/12/2021
ACTIVE CODES: P1151 COOLANT HEAT STORAGE TANK. AT THE TIME OF DIAGNOSE TECHNICIAN ACTIVATE THE HEAT PUMP WITH SCAN TOOL AND NO ENGAGEMENT FROM PUMP RECOMMEND REPLACEMENT. AFTER HEAT STORAGE PUMP REPLACED AND ROAD TEST VEHICLE TRIANGLE LIGHT CAME BACK ON WITH A DIFFERENT CODE P0A93 INVERTER SYSTEM COOLANT PERFORMANCE WHEN DIAGNOSE FOUND THAT THE HIGH VOLTAGE PUMP WAS NOS WORKING PROPERLY AS WELL AS COOLANT FLOW. RECOMMEND REPLACEMENT AS WELL.
BRAKE SHOES &/OR PADS – Remove & Replace – Rear,Both Sides – [Includes: Clean, lube and/or replace Brake Hardware as necessary. Adjust Brakes (where applicable). Includes: Repack Wheel Bearings (where applicable). DOES NOT include refinishing.]
Change oil and oil filter. Check air filter and breather filter. Check all fluid levels and tire pressures. Preform basic safety inspection. Road test vehicle.
SHOCK &/OR STRUT ASSEMBLY – Remove & Install or Remove & Replace – Both – [DOES NOT include disassemble or alignment.]
SHOCK &/OR STRUT ASSEMBLY – Remove & Install or Remove & Replace – Both – [Includes: Bleed Brake System (where applicable). DOES NOT include disassemble or alignment (where applicable).]
tire balancing
TWO WHEEL ALIGNMENT – Adjustment – Front Axle – [DOES NOT include straightening or replacement of components.]
MARSHAL M. gave our service a 5 star review on 3/18/2020